We often see some shoot camera vehicle driving conditions on the road , they set up in some bar , we put this bar called camera pole , though it is just a simple pole , it may have not produced fewer requirements.

At present our production of materials for standard camera pole is strength q235, wall thickness of no less than 4mm, the bottom flange thickness not less than 14mm, otherwise it is very difficult to stand up to the camera pole storms . In addition, as no matter which region , storms and earthquakes and other natural disasters can occur at any time , so the camera pole required seismic capacity is generally not less than six , wind power capacity have more than eight .

When welding camera pole , rod does not require the entire weld , no welding defects , so electric welding better. Finally, the surface had to be re- passivated galvanized to prevent rust corrosion finally drained it happened .

After installation but also a good production , we require the installation of the camera pole must be vertical , generally in order to ensure its verticality , we will adopt a two-phase vertical theodolite detection of rod disparity between the two should be 1.0 ≤ %. After all done, the camera pole to be put into use , the actual effect of the use of such a camera pole will also be better .